eprintid: 8590
rev_number: 20
eprint_status: archive
userid: 1903
dir: disk0/00/00/85/90
datestamp: 2011-08-10 09:33:11
lastmod: 2016-04-20 17:19:30
status_changed: 2011-08-10 09:33:11
type: article
metadata_visibility: show
item_issues_count: 0
creators_name: Diez Cifuentes, Eduardo
creators_name: Perez Garcia, Hilde
creators_name: Guzman Villaseñor, Mario
creators_name: Vizán Idoipe, Antonio
title: Dynamic analysis of runout correction in milling
ispublished: pub
subjects: mecanica
keywords: Milling; Tool runout; Cutting force control; Piezoelectric actuator
abstract: Tool runout and its effects is an important area of research within modelling, simulation, and control of milling forces. Tool runout causes tool cutting edges to experience uneven forces during milling. This fact also affects tool life and deteriorates workpiece surface quality. In this article a procedure, in order to diminish the effects of tool runout, is presented. The procedure is based on chip thickness modification by means of the fast correction of the tool feed rate. Dynamic feed rate modification is provided by superposing our own design of a fast feed system driven by a piezoelectric actuator to the conventional feed drive of the CNC machine tool. Previously, a model of the dynamic behaviour of the system was developed to analyze the influence of fast feed rate modification on cutting forces. The model incorporates the piezoelectric actuator response as well as the structural dynamics of the tool and the designed Fast Feed Drive System (FFDS). Simulated and experimental results presented in this paper show the effectiveness and benefits of this new tool runout correction procedure.
date: 2010-08
date_type: published
publisher: Elsevier
official_url: http://www.sciencedirect.com/science/journal/08906955
id_number: 10.1016/j.ijmachtools.2010.04.010
full_text_status: public
publication: International Journal of Machine Tools and Manufacture
volume: 50
number: 8
pagerange: 709-717
institution: Industriales
department: Ingenieria_Mecanica
refereed: TRUE
issn: 0890-6955
rights: by-nc-nd
citation:   Diez Cifuentes, Eduardo and Perez Garcia, Hilde and Guzman Villaseñor, Mario and Vizán Idoipe, Antonio  (2010).  Dynamic analysis of runout correction in milling.   "International Journal of Machine Tools and Manufacture", v. 50  (n. 8);   pp. 709-717.  ISSN 0890-6955.   https://doi.org/10.1016/j.ijmachtools.2010.04.010 <https://doi.org/10.1016/j.ijmachtools.2010.04.010>. 
document_url: https://oa.upm.es/8590/2/INVE_MEM_2010_84719.pdf