2023-03-22T23:08:29Z
https://oa.upm.es/cgi/oai2
oai:oa.upm.es:19999
2016-04-21T22:09:07Z
7374617475733D707562
7375626A656374733D636F6E737472756363696F6E
747970653D636F6E666572656E63655F6974656D
Computational Methods for Identification of Vibrating Structures
Cara Cañas, Francisco Javier
Carpio Huertas, Jaime
Juan Ruiz, Jesús
Alarcón Álvarez, Enrique
Civil Engineering and Construction
System identification deals with the problem of building mathematical models of dynamical systems based on observed data from the system" [1]. In the context of civil engineering, the system refers to a large scale structure such as a building, bridge, or an offshore structure, and identification mostly involves the determination of modal parameters (the natural frequencies, damping ratios, and mode shapes).
This paper presents some modal identification results obtained using a state-of-the-art time domain system identification method (data-driven stochastic subspace algorithms [2]) applied to the output-only data measured in a steel arch bridge.
First, a three dimensional finite element model was developed for the numerical analysis of the structure using ANSYS. Modal analysis was carried out and modal parameters were extracted in the frequency range of interest, 0-10 Hz. The results obtained from the finite element modal analysis were used to determine the location of the sensors.
After that, ambient vibration tests were conducted during April 23-24, 2009. The response of the structure was measured using eight accelerometers. Two stations of three sensors were formed (triaxial stations). These sensors were held stationary for reference during the test. The two remaining sensors were placed at the different measurement points along the bridge deck, in which only vertical and transversal measurements were conducted (biaxial stations).
Point estimate and interval estimate have been carried out in the state space model using these ambient vibration measurements. In the case of parametric models (like state space), the dynamic behaviour of a system is described using mathematical models. Then, mathematical relationships can be established between modal parameters and estimated point parameters (thus, it is common to use experimental modal analysis as a synonym for system identification). Stable modal parameters are found using a stabilization diagram.
Furthermore, this paper proposes a method for assessing the precision of estimates of the parameters of state-space models (confidence interval). This approach employs the nonparametric bootstrap procedure [3] and is applied to subspace parameter estimation algorithm. Using bootstrap results, a plot similar to a stabilization diagram is developed. These graphics differentiate system modes from spurious noise modes for a given order system.
Additionally, using the modal assurance criterion, the experimental modes obtained have been compared with those evaluated from a finite element analysis. A quite good agreement between numerical and experimental results is observed.
E.T.S.I. Industriales (UPM)
https://creativecommons.org/licenses/by-nc-nd/3.0/es/
2009
info:eu-repo/semantics/conferenceObject
Presentation at Congress or Conference
Proceedings of the Twelfth International Conference on Civil, Structural and Environmental Engineering Computing | 12th. International Conference on Civil, Structural and Environmental Engineering Computing | 01/09/2009-4/09/2009 | Funchal, Madeira (Portugal)
PeerReviewed
application/pdf
eng
http://www.ctresources.info/ccp/paper.html?id=5465
info:eu-repo/semantics/openAccess
https://oa.upm.es/19999/