Reproducing the Bolund experiment in wind tunnel

Yeow, Tee Seong and Cuerva Tejero, Alvaro and Perez Alvarez, Javier (2013). Reproducing the Bolund experiment in wind tunnel. "Wind Energy" ; pp. 1-17. ISSN 1095-4244.


Title: Reproducing the Bolund experiment in wind tunnel
  • Yeow, Tee Seong
  • Cuerva Tejero, Alvaro
  • Perez Alvarez, Javier
Item Type: Article
Título de Revista/Publicación: Wind Energy
Date: December 2013
ISSN: 1095-4244
Faculty: E.T.S.I. Aeronáuticos (UPM)
Department: Otro
Creative Commons Licenses: Recognition - No derivative works - Non commercial

Full text

PDF - Requires a PDF viewer, such as GSview, Xpdf or Adobe Acrobat Reader
Download (1MB) | Preview


The Bolund experiment has been reproduced in a neutral boundary layer wind tunnel (WT) at scale 1:115 for two Reynolds numbers. All the results have been obtained for an incoming flow from the 270o wind direction (transect B in the Bolund experiment jargon). Vertical scans of the velocity field are obtained using non-time resolved two components particle image velocimetry. Time-resolved velocity time series with a three component hot-wire probe have been also measured for transects at 2 and 5 m height and in the vertical transects at met masts M6, M3 and M8 locations. Special attention has been devoted to the detailed characterization of the inflow in order to reduce uncertainties in future comparisons with other physical and numerical simulations. Emphasis is placed on the analysis of spectral functions of the undisturbed flow and those of the flow above the island. The result?s reproducibility and trustworthiness have been addressed through redundancy measurements using particle image velocimetry, two and three components hot-wire anemometry. The bias in the prediction of the mean speed is similar to the one reported during the Bolund experiment by the physical modellers. However, certain reduction of the bias in the estimation of the turbulent kinetic energy is achieved. TheWT results of spectra and cosprectra have revealed a behaviour similar to the full-scale measurements in some relevant locations, showing that WT modelling can contribute to provide valid information about these important structural loading factors.

More information

Item ID: 31109
DC Identifier:
OAI Identifier:
Deposited by: Memoria Investigacion
Deposited on: 22 Oct 2014 15:16
Last Modified: 22 Oct 2014 15:16
  • Logo InvestigaM (UPM)
  • Logo GEOUP4
  • Logo Open Access
  • Open Access
  • Logo Sherpa/Romeo
    Check whether the anglo-saxon journal in which you have published an article allows you to also publish it under open access.
  • Logo Dulcinea
    Check whether the spanish journal in which you have published an article allows you to also publish it under open access.
  • Logo de Recolecta
  • Logo del Observatorio I+D+i UPM
  • Logo de OpenCourseWare UPM